FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 200)

4 – Appendices NET SatisFAXtion 8.7 Manual 200
%4!u! day
%5!u! year
%6!u! hour (for 24 hour format i.e. 0–23)
%7!u! minutes
%8!s! short month name string
%9!s! long month name string
%10!u! year % 100 (2 digit year)
%11!u! hour (for 12 hour am/pm format)
%12!s! am/pm string for 12 hour format
Be very careful what you specify in the string as as it is passed directly through
and if you specify a string type for a parameter that is an int you will most likely
cause a UAE. For instance, if you put in %2 or %2!s!, then the passed page num-
ber parameter will be used as a pointer to a string by FormatMessage. A page
number of 1 would be a bad string address and would cause a UAE. Default:
From:%1!-20.20s! Page#:%2!u! Date:%3!u!/%4!u!/%5!u! %6!u!:%7!
2.2u!
.
send_burst_topmost [dword 0–65535]: Default:
10
.
send_burst_highwater [dword 0–65535]: Default:
8
.
send_burst_delay_msecs [dword 0–65535]: When submitting a lot of mes-
sages at once, this has been shown to make a small improvement without FILE-
BASE, and a significant improvement with FILEBASE. Default:
500 .
send_retry_seconds [dword 0–65535]: The amount of time in seconds to
elapse before attempting to resend a message after any retryable reason other
than the remote unit being busy. Default:
15 .
strip_header_line_count [string]: How many scan lines to strip from the top
of each page of a receive fax. This is a per device setting.
tsid [string(20)]: This sets a default CSID to use when transmitting if the
SFAX_CONTROLS structure has NULL for its local_csid field. If this setting is
not present, the csid setting in the fax driver registry section for this device
will apply.
max_pages [dword 0–65535]: Default:
0 .
min_disk_free_kbytes [dword 0–65535]: ICANFax checks disk space every
minute. When free space falls below the specified threshold, ICANFax sets the
global comm state to disable receives and applies the
diskfull_receiving
setting for each port. Sends are unaffected. When disk space rises above the
threshold, everything returns to normal. This is not implemented in the Win32
ICANFax. Default:
1000 .
mode [string]: Sets whether this device sends, receives, both, or neither. This
setting must be present. When the application specifies "*" for "first available"
device when sending a message, devices set to
FAX_OUT
only have higher priori-
ty than devices set to
FAX_IN
,
FAX_OUT
. This is to prevent devices that are set
to both send and receive from sending a message, thus being unavailable for re-