FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 211)

4 – Appendices NET SatisFAXtion 8.7 Manual 211
the driver when either the 6 second interdigit DTMF timeout occurs or the
dtmf_terminate_digits
is received. This has the same format rules as
dtmf_detection_begin . Format: Up to 80 characters.
dtmf_digit_count [dword 0–31]: Max number of DTMF digits to receive. Set-
ting 0 disables this. Default:
0 .
dtmf_terminate_digit [string]: The received DTMF digit that causes the driver
to terminate DTMF digit collection being done by the modem by sending the
dtmf_detection_end string. Leave blank to not use a terminate character.
Format: 0 or 1 characters, typically # or *. Default: # .
dtr_toggle_msecs [dword 0–65535]: This is how long to keep the DTR line
low during reset or close so that a modem will hangup the line and return an
OK
.
Default:
200
.
enable_init_flow_control [boolean]: This is for the rare modems that return
OK
following
ATZ
and have CTS low because they are unable to accept another
command. This will probably never be used since ATZ is not sent for user init.
Default:
false
.
get_receive_image_end_ok_timeout_msecs [dword 0–65535]: This is how
long to wait for an
OK after receiving the DLE / ETX sequence that terminates a
receive image. The modem will receive the post page signal during this period.
When the driver receives the
OK , it will send a +FDR and either start waiting for
an image CONNECT if a MPS / EOP was received by the modem or start waiting for
a pre-phase OK because an EOM was received by the modem. Default: 30000 .
get_receive_image_start_connect_timeout_msecs [dword 0–65535]: This
is how long to wait for a
CONNECT after sending +FDR . The modem will usually
perform its training during this period. If it returns an OK during this time the
driver will assume it has reported a new DCS and is stepping down its training
rate. The driver will re-issue the FDR and restart this timeout. If a modem steps
through all training rates without returning new DCS / OK responses, this timeout
would need to be quite large to achieve connection. Smaller values will return
control to the application sooner when connections fail. Default:
60000 .
get_receive_pre_phase_ok_timeout_msecs [dword 0–65535]: This is how
long to wait for an
OK while in the initial pre-phase of a fax receive. When the
driver receives an OK it will send a +FDR . The modem usually exchanges TSI / CSI
and DIS / DCS in this time period. Default: 35000 .
get_send_image_start_connection_timeout_msecs [dword 0–65535]: This
is how long to wait for a
CONNECT after sending +FDT to release the modem to
send the
TSI
/
DCS
and perform training. If the modem returns an
OK
the driver
will assume it has received an FTT and is stepping down to a new baud rate.
The driver will re-issue the +FDT and restart this timeout. If a modem steps
through all training rates without returning new DCS / OK responses, this timeout
would need to be quite large to achieve connection. Smaller values will return
control to the application sooner when connections fail. Default:
60000 .
get_send_post_phase_ok_timeout_msecs [dword 0–65535]: This is how
long to wait for the
OK
after sending the
+FET
command. The modem will re-