FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual User Manual

Page 215

Advertising

4 – Appendices

NET SatisFAXtion 8.7 Manual

215

show_ring0_buffer_size [dword 0–4294967295 ]: How big of buffer for
the page locked debug buffer that ring0 code writes to and ring3 code extracts
from (on a thread) to the debugging output. This should be larger for when us-
ing serial capture mode since so much more data is written for debug. It should
probably be only about 1K for when using T.30 debug since the frequency and
amount of T.30 debug is small enough that the ring3 code can easily keep up
writing to the show output. Default:

65536

debug_show_file_path [string(256)]: Partial path or complete path and file
name of where to create debug file. If the debug_show_output is set for CON-
SOLE and the debug_show_file_path is specified in the registry, then you can
get both CONSOLE and FILE debug output simultaneously. This is a device spe-
cific setting, but you can set the default for all devices by specifying this under
the global icanfax section.
csid [string(20)]: The CSI for receive and the TSI for send.
allowed_receive_image_types [string]: These settings control the image
types that the device can send and receive via the T.30 protocol over the tele-
phone network. To receive or send some image types, the corresponding

al-

lowed_receive

send_transfer_type

setting must include ECM. Format:

Comma separated list of the following. Default:

1D,2D,T6,JBIG

1D
2D
T6
JPEG
JBIG
COLOR
200H_400V
300H_300V
400H_400V

allowed_receive_transfer_types [string]: These settings control the type of
fax and file transfers that the driver can perform for a device. Format: Comma
separated list of the following. Default:

FAX,ECM,V34

FAX
ECM
V34

allowed_send_image_types [string]: These settings control the image types
that the device can send and receive via the T.30 protocol over the telephone
network. To receive or send some image types, the corresponding

allowed_receive