FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 216)

4 – Appendices NET SatisFAXtion 8.7 Manual 216
allowed_send_transfer_types [string]: These settings control the type of fax
and file transfers that the driver can perform for a device. Format: Comma sep-
arated list of the following. Default:
FAX,ECM,V34 .
FAX
ECM
V34
dial_prefix [string(20)]: Data to be prepended to dial strings, typically 9, if
present.
4.2.1.3.1
Class2 Device
allowed_receive_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400 , 12000 , 9600 , 7200 , 4800 and 2400 . Default:
14400,12000,9600,7200,4800,2400 .
allowed_send_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400 , 12000 , 9600 , 7200 , 4800 and 2400 . Default:
14400,12000,9600,7200,4800,2400 .
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “an-
swering” states for a carrier from the remote device before hanging up. De-
fault:
45
.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state be-
fore hanging up. Default:
45
.
tapi_modem_name [string(128)]: When specified, the driver will utilize TAPI
so as to not monopolize the usage of the serial port. This is the name of the
modem defined in the control panel modem applet.
tapi_modem_name_saved [string(128)]: Copy of
tapi_modem_name .
fax_device_name [string(32)]: Optional device name that will override the key
name that is used for the fax device name. Typically this is never used.
csid [string(20)]: The CSI for receive and the TSI for send.
4.2.1.4
Convert
header_font [string]: Font used for fax header text conversion. Default:
{ProgramPath}\Fonts\header.fnt
.