FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 55)

2 – Server Administration NET SatisFAXtion 8.7 Manual 55
Port 1: 1000
Port 2: 1001
Port 3: 1002
Port 4: 1003
Port 5: 1004
Port 6: 1005
Port 7: 1006
Port 8: 1007
The phone numbers typically configured on a Mediant 1000 are slightly differ-
ent. Note that Mediant 1000s often have customized configuration and so the
following does not necessarily reflect your Mediant’s configuration.
Module 1 Port 1: 1000
Module 1 Port 2: 1001
Module 1 Port 3: 1002
Module 1 Port 4: 1003
Module 2 Port 1: 2000
Module 2 Port 2: 2001
Module 2 Port 3: 2002
Module 2 Port 4: 2003
Module 3 Port 1: 3001
etc...
2.5.1.7.2
Brooktrout Fax Cards
Any Brooktrout analog (loopstart) fax card is capable of routing on Line or
DTMF. These cards must use
DTMF Setup to enable DTMF digit capture on
these cards.
Any Brooktrout DID fax card is capable of routing on DNIS. No additional con-
figuration is necessary.
Brooktrout T1/PRI cards are capable of routing on DNIS. No additional configu-
ration is necessary.
2.5.1.7.3
Eicon Diva Server
Eicon Diva Servers are capable of routing on DNIS from the T1 or PRI.
2.5.1.7.4
MainPine RockForce / IQ Express
Any MainPine analog fax card is capable of routing on Line or DTMF. These
cards must use DTMF Setup to enable DTMF digit capture on these cards.
2.5.1.7.5
Any T1 or PRI Equipment / Any Other VoIP Equipment
DNIS is normally captured and can be used to route faxes. No additional con-
figuration is necessary.