FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 205)

4 – Appendices NET SatisFAXtion 8.7 Manual 205
dtmf_terminate_digit [string]: The received DTMF digit that causes the driver
to terminate DTMF digit collection being done by the modem by sending the
dtmf_detection_end string. Leave blank to not use a terminate character.
Format: 0 or 1 characters, typically # or *. Default:
#
.
dtr_toggle_msecs [dword 0–65535]: This is how long to keep the DTR line
low during reset or close so that a modem will hangup the line and return an
OK .
Default: 200 .
enable_init_flow_control [boolean]: This is for the rare modems that return
OK following ATZ and have CTS low because they are unable to accept another
command. This will probably never be used since ATZ is not sent for user initial-
ization. Default: false .
hangup_timeout_msecs [dword 0–65535]: This is how long to wait for
ATH0
command to complete. Default:
2000
.
line_type [string]: When
dtmf_prompt
is specified, the
dtmf_detection_be-
gin_string will be sent at the start of the call and received DTMF digits will
be collected from the modem up until either a
dtmf_terminate_digit
is re-
ceived or a 6 second inter-digit timeout occurs or a CNG tone is detected or
dtmf_digit_count
number of digits are collected. Default:
NORMAL
.
next_ring_response_timeout_msecs [dword 0–65535]: This is how many
msecs to wait after a ring from the modem before resetting the internal ring
counter. This will only apply for
rings_before_answer greater than 1 and
when not using TAPI. Default: 7500 .
on_hook_msecs [dword 0–65535]: This is the minimum amount of time after
the modem goes on hook from a prior connection before the driver will start a
new connection (dial). This will allow the phone system to have time to discon-
nect the call upon noticing the modem on hook. Default:
200 .
pause_before_send_command_msecs [dword 0–65535]: This specifies how
long to pause when the protocol state is idle, answering, or dialing, before
sending the "
AT " command. There are some modems that upon sending an OK
from a subsequent command, must have time to get ready to receive new char-
acters from the
DTE . Default: 100 .
periodic_reset_timeout_msecs [dword 0–4294967295]: How often a reset
sequence should be done to verify modem integrity. It is understood that some
modems may periodically hang or go into a disabled power saver type of mode
or that they may be turned off and on but the
DSR
modem control change is not
detected possibly because TAPI is being used. Therefore, the driver will reset
the modem when it is idle for this amount of time. Setting this to 0 will disable
this periodic reset feature. Default:
600000 .
receive_image_modulation_timeout_msecs [dword 0-65535]: How long to
wait without receiving any image data before canceling the reception of image
data. There is a USR modem that sometimes fails to send a
DLE
/
ETX
sequence
at the end of image data. By having this timeout short enough, the driver will
abort the image receive in a timeliness manner so as to receive one of the sub-
sequent end of page commands. Default:
3000
.