FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 207)

4 – Appendices NET SatisFAXtion 8.7 Manual 207
rings_before_answer [dword 0–255]: Number of rings before modem ac-
cepts call. Default:
1
.
ser_device_name [string]: Win32 name for the serial port in the format of
COMXXX where XXX can be 001–999. This does not need to be specified if
the
tapi_modem_name is specified. Format: Up to 6 characters.
init_string [string]: This is the basic modem initialization string. It should reset
the modem and init the required flow control. Format: Up to 80 characters.
Default:
&F&C1&D2V1E0S0=0S7=90^^ .
All modem commands start with AT, so this string does not need AT. The sym-
bols in the string mean the following:
^ 2-second pause
\ Carriage return. There is a wait of
init_string_timeout_msecs after carriage return to wait
an OK to be returned.
\\
Specifies a single
\
^^\ this is interpreted as \^^
init_string_timeout_msecs [dword 0–65535]: How long to wait for re-
sponse after
CR in the init_string if there are no 2-second pauses before or
after the CR . Default: 5000 .
close_string [string]: Determines what commands should be sent to a fax mo-
dem to restore it to its normal state of operation after the application has fin-
ished using it. See
init_string description for string format explanation.
Default: Z^^ .
io_buffer_size [dword 0–65535]: This is the size of the image buffer. The
necessary buffer size depends on host CPU speed and load as well as connect
speed. This buffer directly adds to driver page locked memory use so should be
as small as possible. However, too small a buffer will cause faxes to fail. De-
fault:
20480 .
show_console_scroll_back_buffer_size [dword 0–4294967295]: When
the debug output is
CONSOLE
, this is how big of a buffer to be used for scroll-
back. Default:
282144
.
show_ring0_buffer_size [dword 0–4294967295 ]: How big of buffer for
the page locked debug buffer that ring0 code writes to and ring3 code extracts
from (on a thread) to the debugging output. This should be larger for when us-
ing serial capture mode since so much more data is written for debug. It should
probably be only about 1K for when using T.30 debug since the frequency and
amount of T.30 debug is small enough that the ring3 code can easily keep up
writing to the show output. Default:
65536
.
debug_show_file_path [string(256)]: Partial path or complete path and file
name of where to create debug file. If the
debug_show_output is set for CON-
SOLE and the debug_show_file_path is specified in the registry, then you can
get both CONSOLE and FILE debug output simultaneously. This is a device spe-