FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 26)

2 – Server Administration NET SatisFAXtion 8.7 Manual 26
Please note that the media gateway must support SIP and T.38 protocols, and
must initiate T.38 on detection of fax tone for outbound faxes. (For inbound
faxes, NET SatisFAXtion will initiate T.38.)
2.2.2.2.4
SIP Trunk Provider
If you are using a SIP provider, click on the Show Advanced Settings link to en-
able manual configuration. For providers that do not require authentication or
registration (i.e. they use IP authentication), simply enter the IP address speci-
fied by the provider.
If you require
authentication and registration, choose the radio option t hrough
this SIP proxy/server . Enter the remote IP address specified by the provider
and fill in the required user name and password . Usually AoR will be the same
as the user name. It will be used in the SIP REGISTER messages as the part of
the From URI before the @.
Please note that the provider must support SIP and T.38 protocols, and must
initiate T.38 on detection of fax tone for outbound faxes. (For inbound faxes,
NET SatisFAXtion will initiate T.38.)
2.2.2.3
Using Multiple VoIP Gateways
NET SatisFAXtion will answer all calls sent to it, so there is no additional con-
figuration necessary to
receive calls from multiple gateways.
To use multiple gateways to send calls, some additional registry configuration is
required.
2.2.2.4
Fax Server with Multiple Network Interface Cards
A fax server with multiple network interface cards (NICs) presents a special
problem. All SIP communication will use the IP address of the first adapter in
the binding order. To check the binding order, open the
Control Panel Net ⇨ -
work Connections folder. Click the Advanced Advanced Settings ⇨ menu. All
the network connections on the server will be listed here, move the connection
that that should be used to the top.
Alternately, you can manually override the IP address used by going to the
Change Server Settings utility, Start Programs NET SatisFAXtion ⇨ ⇨ ⇨
Change Server Settings . Click the Fax Hardware button, select a port, click Ad-
vanced , then click More Settings .
Make sure the IP address you enter is valid for this server. If using a domain
name, make sure the name resolves from the media gateway
and the IP it re-
solves to is valid for this server.