FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 54)

2 – Server Administration NET SatisFAXtion 8.7 Manual 54
2.5.1.4
CSID Routing
Prone to failure.
Disabled by default. To enable:
[HKLM\Software\FaxBack\CasDrive]
"RouteOnCsid" = "1"
2.5.1.5
Caller ID / ANI Routing
Prone to failure.
Disabled by default. To enable:
[HKLM\Software\FaxBack\CasDrive]
"RouteOnAniCallerId" = "1"
2.5.1.6
T.30 Subaddress Routing
The T.30 fax specification allows an additional identifier to be specified by the
sender for routing purposes. This feature was never widely implemented when
it was first introduced, and is almost never implemented today.
Disabled by default. To enable:
[HKLM\Software\FaxBack\CasDrive]
"RouteOnT30SubAddress" = "1"
"SubAddressSeparator" = "#"
Subaddress is transmitted via a T.30 HDLC SUB frame, 20 characters in length.
The allowed chars for SUB are numbers, space, *, and #”.
2.5.1.7
Inbound Routing Capabilities By Device
2.5.1.7.1
AudioCodes MediaPack, Mediant, and TrunkPack
AudioCodes MediaPacks (FXO ports) are capable of routing on Line or DTMF.
AudioCodes MediaPacks (FXS ports) are DID Trunk capable, and can route on
DNIS.
AudioCodes TrunkPack (TP260) cards, Mediant 1000s with T1/PRI cards, Me-
diant 2000 and 3000 gateways are capable of routing on DNIS. No additional
configuration is necessary.
2.5.1.7.1.1 Emulating Line Routing
The standard configuration NET SatisFAXtion applies enables line routing
through the use of virtual phone numbers. The DID number NET SatisFAXtion
receives will indicate on which port the MediaPack or Mediant received the fax.
To use these line phone numbers, follow the instructions for DID routing
above, and use the port phone numbers given below.
The phone numbers on AudioCodes MediaPack MP114 and MP118s default to
the following: