FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 206)

4 – Appendices NET SatisFAXtion 8.7 Manual 206
send_image_modulation_timeout_msecs [dword 0–4294967295]: This is
how long to wait after sending a block of send image data to the modem before
assuming the modem is having problems. This number should be large enough
to account for the time done by the modem and serial driver buffering. Default:
200000
.
slow_at_pause_msecs [dword 0–65535]: This is how many msecs to pause
in the middle and at the end of the "
AT " for any command sent after a baud rate
change. This gives the modem time to auto baud and detect data/stop bit for-
mat before returning to its normal command interpreting state. Use this for old
modems. Default:
100 .
speaker_mode [string]: State of device’s speaker. This translates to an ATM#
command. Default: ON_UNTIL_CARRIER .
speaker_volume [string]: Volume of device’s speaker. This translates to an
ATL# command. Default: LOW .
stolen_port_restore_timeout_msecs [dword 0–65535]: This was used in
Win 16 and DOS, but probably does not have any application for when using
TAPI in Win 32 since the Unimodem driver is in control or modem reinit when
an app is done using a port. When not using TAPI in Win32, there is no way
that the port can be stolen in the first place. Default:
1000
.
allowed_receive_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400
,
12000
,
9600
,
7200
,
4800
and
2400
. Default:
14400,12000,9600,7200,4800,2400
.
allowed_send_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400 , 12000 , 9600 , 7200 , 4800 and 2400 . Default:
14400,12000,9600,7200,4800,2400 .
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “an-
swering” states for a carrier from the remote device before hanging up. De-
fault:
45 .
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state be-
fore hanging up. Default:
45 .
flow_control [string]: Designates the type of flow control to use when send-
ing data. If the setting is
XON_XOFF
the driver observes
XOFF
signals when
sending. The driver uses no flow control when receiving. Format: Either
XON_XOFF
or
RTS_LEVEL
. Default:
RTS_LEVEL
.