FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 27)

2 – Server Administration NET SatisFAXtion 8.7 Manual 27
This will set the registry key
[HKLM\Software\FaxBack\IP_FAX]
local_ip_address which indicates the IP address to use for SIP communica-
tion.
2.2.3
Class 1 / Class 2
Most internal and external serial modems use the Class 1 or Class 2 command
set.
2.2.3.1
Configuring NET SatisFAXtion to use a Class 1 or Class 2 device
NET SatisFAXtion can use most Class 1 or Class 2 fax modems to send and re-
ceive faxes.
Class 1 or Class 2 devices are initially configured in
Re-Detect Fax Devices . En-
sure that the modem’s drivers are already installed and Windows has detected
them. Configured modems will be listed in Window’s
Phone and Modem Op-
tions control panel.
Modems cannot be shared between applications, so ensure that no other tele-
phony application is installed on the fax server. If there are other applications
using the modems, NET SatisFAXtion will report that it cannot access the de-
vice (“Windows serial device name unknown”). If you have no other telephony
applications installed, check the Remote Access Connection Manager service:
disable it, reboot and try again (Windows will not allow you to manually stop
this service).
2.2.4
Dialogic Brooktrout TR114
Dialogic Brooktrout TR114 cards are natively supported by NET SatisFAXtion,
and no additional driver software is required.
These fax cards are configured in
Re-Detect Fax Devices .
2.2.5
Dialogic Brooktrout TR1034
Dialogic Brooktrout TR1034 cards are supported by NET SatisFAXtion using
the
bos_man_setup
utility. No additional driver software is required.