FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 223)

4 – Appendices NET SatisFAXtion 8.7 Manual 223
t38_qos_delay_variation [string]: DelayVariation of sending T.38 RSVP
FlowSpec. Default:
QOS_NOT_SPECIFIED
.
t38_qos_service_type [string]: ServiceType of sending T.38 RSVP FlowSpec.
Default:
SERVICETYPE_GUARANTEED .
t38_qos_max_sdu_size [dword 0–65535]: MaxSduSize of sending T.38
RSVP FlowSpec. Default:
340 .
t38_qos_minimum_policed_size [dword 0–65535]: MinimumPolicedSize of
sending T.38 RSVP FlowSpec. Default:
340
.
4.2.1.5.1
IP_FAX Device
allowed_receive_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400
,
12000
,
9600
,
7200
,
4800
and
2400
. Default:
14400,12000,9600,7200,4800,2400
.
allowed_send_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400
,
12000
,
9600
,
7200
,
4800
and
2400
. Default:
14400,12000,9600,7200,4800,2400 .
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “an-
swering” states for a carrier from the remote device before hanging up. De-
fault:
45 .
csid [string(20)]: The CSI for receive and the TSI for send.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state be-
fore hanging up. Default:
45
.
fax_device_name [string]: Optional device name that will override the key
name that is used for the fax device name. Typically this is never used. Format:
Up to 32 characters.
phone_number [string]: Specifies a value that the IP fax driver sets in the
From: header of SIP messages that it creates, identifying the IP fax port. A
VoIP router can, if so configured, pass along this value as the caller ID (ANI)
for the outbound fax call.