FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 201)

4 – Appendices NET SatisFAXtion 8.7 Manual 201
ceives, when a device set to only send is available. This is a device specific set-
ting, but you can set the default for all devices by specifying this under the
global ICANFax section. Format: Comma separated list of
FAX_IN and
FAX_OUT
, or
disabled
. Default:
FAX_IN, FAX_OUT
.
order [string]: This is used to control the ordering of devices so that particular
devices will be used for "send any" events before others. This will also be the
order that they are shown from applications like the monitor or Administration.
It does not need to contain all of the fax devices – only those that you want
sorted at to head of the linked list of devices. Format: Comma separated list of
port names.
rtp_percent [dword 0–100]: This is the percentage of bad scan lines to good
scan lines that will cause ICANFax to respond with an RTP to the fax driver.
This only applies when doing non-ECM fax receive and the driver is configured
for a post page holdup. If post receive convert is enabled or the debug pages
are enabled, ICANFax will always respond to the driver holdup with an MCF as
the conversion is not done in real time. Setting to
0 disables RTP. Default: 5 .
rtn_percent [dword 0–100]: This is the percentage of bad scan lines to good
scan lines that will cause ICANFax to respond with an RTP to the fax driver.
This only applies when doing non-ECM fax receive and the driver is configured
for a post page holdup. If post receive convert is enabled or the debug pages
are enabled, ICANFax will always respond to the driver holdup with an MCF as
the conversion is not done in real time. This value will take precedence over the
rtp_percent . Setting to 0 disables RTN. Default: 10 .
send_all_pages_on_retry [string]: Tells ICANFax how to send pages when
retrying (with reconnect) a fax that partially succeeded. There are three op-
tions, as follows:
YES
Send whole message again.
NO Send first page of the message (usually the cover) plus un-
sent pages.
UNSENT_ONLY Send only unsent pages. Unsent pages means the first page
that was not successfully sent, plus all following pages to
the end of the message
queues_path [string]: Name of queues directory. Default: Queues .
validation_dll [string]: Path to validation dll.
4.2.1.1.1
ICANFax Device
pause_before_send [dword 0–65535]: This sets the time in seconds to wait
before sending a message that is due to go out. Set this to a value greater than
0 to allow boards some time to answer calls between sends when they have
multiple send messages waiting to go out. Some devices need this also because
they don’t have the min on hook feature that guarantees the call from a prior
connection has had enough time to disconnect. This is a device specific setting,
but you can set the default for all devices by specifying this under the global
ICANFax section. Default:
0
.