FaxBack NET SatisFAXtion 8.7 (Including R3) - Manual - Manual (Page 97)

2 – Server Administration NET SatisFAXtion 8.7 Manual 97
The receiver’s name, if any. Set by the sender.
[Sender_Name] [varchar](100)
The sender’s Caller ID (ANI). Note that not all fax devices collect Caller ID
from the phone call.
[Submit_Time] [datetime]
When the fax was submitted to the fax server.
[Schedule] [datetime]
When the fax was scheduled for. If the fax was not scheduled for some time
after it was submitted,
[Schedule] will equal [Submit_Time] .
[Start_Time] [datetime]
When the fax began actually sending. On a receive fax this will equal
[Submit_Time] .
[Original_User_Name] [varchar](50)
The user who actually submitted the fax to the server. For example, email faxes
will come from the
SMTPPOST user.
[User_Name] [varchar](50)
The user who sent the fax.
[Source_Num] [int]
The application used to submit the fax.
0: Unknown
1: WinFax (deprecated)
2: Exchange MAPI gateway (deprecated)
3: Notes Domino gateway (deprecated)
5: SMTP or POP3 email gateway
9: Administration
15: Email Autoenroll
18: FAXability
[User_Billing_Code] [varchar](50)
User billing code, see 2.8.1 User Billing Codes .
[Custom_Billing_Code] [varchar](50)
Custom, user-provided billing code. See 2.8.2 Custom Billing Codes .
[Server_Name] [varchar](50)
The name of the server that received or sent the fax.
[Port_Used] [varchar](50)
The name of the port used to send or receive the fax. IPF_XXXX ports do not
correspond to the actual port on the media gateway used.
[Message_Completion_Code] [int]
Error code. “0” indicates success. See 4.1 Error Code Reference for a list of er-
ror codes.
[ICANFax_Completion_Code] [int]
Internal ICANFax error code.