KEYENCE DV-90 - Manual (Page 32)

2-8
2
Initial Setup
of the Cod
e
Reade
r
E DV-90-IM
2-3
Read Test Procedure of the BL Series and the SR Series
This section describes how to perform the read test for the BL Series and the SR Series.
Read Test Using the Key
The following procedure performs the read test using the key.
The same operation can be performed by turning on/off the trigger input.
1
Press the key on the DV-90.
2
Select “CR1” by pressing the key on the DV-90.
3
Press the key on the DV-90 and the read-
ing starts.
When a code is read, the data is compared with the
master data, and displayed on the screen.
When the data cannot be read the reading results in an
error, and the screen to the right is displayed.
Repeat steps 1 through 3.
The read test using the key is completed.
Read Rate Test Using “Test Mode 1”
The following procedure performs a read rate test in the test mode.
The reading rate test mode can be activated by sending commands to the BL Series or the SR
Series from the DV-90.
1
Pressing the key on the DV-90 displays
“Test Mode 1 Reader Test” for a second, and
the screen to the right is displayed.
Note
The read test described here is applicable to the BL-1300/700/600/180 and the SR-600/500
Series code readers.
TRG
I n p u t T r i g g e r
* C R 1 < >
TRG
1 2 3 4 5 6 7 8 9 0
R e a d E r r o r ( C R 1 )
TRG
R e a d e r T e s t
>
TEST