Interlogix Topaz User Manual - Manual (Page 183)

Chapter 8
Setup
165
How to add an operator type
1. Start by clicking Clear.
2. Enter the Operator Type Name of up to 16 alphanumeric characters.
3. Enter the Inactivity Time.
4. Using the Allowed field, if desired restrict the functions that this operator type can perform.
5. Select the Level of Restrictions, No Access (the default) or Display Only.
6. Click Save/Add.
How to modify an operator type
1. Click the name for the Operator Type in the list that you wish to modify. A list of operator
functions is listed under Allowed. The Restricted list on the right shows any restricted
functions set for that Operator Type.
2. You can move functions to the Allowed or Restricted lists and set a new Level of
Restriction.
3. Click Save/Add.
How to delete an operator type
1. Click the name for the Operator Type in the list that you wish to delete so that it is highlighted.
The Operator Type Name displays.
2. Click Delete.
3. A message “Are you sure you want to delete this record?” displays. Click OK to continue.
A message “Operation Complete” displays.