Interlogix Topaz User Manual - Manual (Page 347)

Chapter 11
Color Graphics Maps
329
The Color you selected appears in the color block in the Security Area Configuration window, as
shown below.
Figure 226.Security Area Configuration
Start drawing the outline of the area by placing the mouse pointer at the starting point on the map.
Click the left mouse button once to set the starting point. Move the mouse pointer to the next location
and click the left button once again. Repeat this until the entire area is outlined and you have clicked
the mouse button back on the starting point.
After clicking back on the starting point, each point you clicked has a small square block called a
reshaping handle. These reshaping handles allow you to reshape the outline.
To reshape the outline of the area, place the mouse pointer on top of a reshaping handle, click and
hold the left mouse button as you drag the lines to the desired reshape. The two lines that are joined
at the point move together as you drag the handle.
You can delete the outline and redraw by clicking Clear Polygonal.
When you have completed changes to the Security Area Configuration window, click OK.
Save your configuration changes by clicking Save Configuration in the center of the toolbar at
the top of your screen.