Interlogix Topaz User Manual - Manual (Page 338)

Topaz
User Manual
320
Adding Alarm Points to Map
In the Device Tree, locate the alarm point to add. Place the mouse pointer on the alarm icon,
click, and hold down the left mouse button. Drag the icon on the map, and release the mouse button.
When you release the mouse button after dragging the alarm icon onto the map, it opens the Icon
Group window. Then you can assign the icon group that is used for the point you placed on the map.
From the Icon Group drop-down list select the Icon Group you want for the point by scrolling through
the list and clicking on the name on the group.
Figure 218.Icon groups
After you click the name of a icon group, the four icons configured for the group appears in the blocks
below each of the point designations.
To move the icon to a different location on the map, click and hold the left mouse button on the icon
and drag the icon to a new location on the map.
Note: When placing a new point on the map, the icon defaults to a green secure icon even if the point is an active alarm.
When the color graphics is back to online, it checks for the current status of the point and changes the icon
accordingly.
The alarm icons in the tree with the red check mark have already been added to a map and
cannot be added again. If you want to add the icon to a different map you must first delete it from the
current map.
To delete or remove an icon from the map, click and drag the icon back to the tree window and
release the mouse button. The icon disappears and the red check mark on the icon in the tree is
removed.
All the default icons that come already configured on the system are listed below. Additional icon
groups may be added, Check with the system administrator.
Default Alarm Icons (user assignable/configurable)
Icon Description of Alarm Icon Represents
AC Power Failure - Power to the field panel has failed