Interlogix Topaz User Manual - Manual (Page 251)

Chapter 9
Hardware
233
Elevator Floor Definition Page
The Elevator Floor Definition page allows you to setup the relay links to floors and Security Areas
for access authorization. To navigate to the Floor Definition page from any page in the Field Panel
Setup pages, click the Elevator tab button at the top of the window and then click the Floor Def. tab
button. The following page displays.
Figure 170.Elevator: Floor Definition
The column of relay #s on the left of the page are Relay #s in the ACU panel. Floor Names and
Security Areas for authorization are assigned to each relay that is used
The Floor Definition page contains the following information:
Relay # Topaz allows up to 36 relays (0-35) in the ACU panel in the column on the left of the window. The
blue panel on the left of these relays indicates the location and relay number on the selected
panel. This makes linking the correct floor to the correct relay easier. You need to know which floor
button in the elevator cab corresponds to which ACU relay. If needed, use the scrollbar on the right
side of the window to navigate down to all 36 relays.
Note: Different cabs may skip relays/floors.
Floor Name Enter the Floor Name (up to 32 characters) to identify the floor that the relay is linked to. For
example, “Floor 2".
Note:
• The name of the security area for elevator control must be a number such as “3”, not “Floor 3”.
• Click the link arrow to set up an additional Security Area. When setup has been completed,
close the window by clicking Save and continue working in the Elevator Floor screen.