Interlogix Topaz User Manual - Manual (Page 339)

Chapter 11
Color Graphics Maps
321
Note: Default icons shown in the table above represent the alarm condition as secure mode. The icons also have three
others colors that are described below.
The interactive map alarm icons change color to show current status.
Green – In normal secure condition and not masked.
Green Flashing – Returned to normal condition, but needs to be acknowledged and cleared.
Red – Alarm has been acknowledged, but has not cleared (reset) yet.
Red Flashing - A new alarm has been activated that needs to be acknowledged and cleared.
Blue – Alarm is currently masked and does not generate a new alarm condition, but does report
trouble conditions.
Device Offline - Communication to the field device has failed
Door Alarm - Magnetic door contacts on the reader doors.
Duress Alarm - When a duress PIN code has been entered at the keyboard.
Fire Alarm - Auxiliary output from fire panel has activated.
Forced Open - When a reader door is open without authorization.
Glass Break - Alarm glass break detector has been activated while not masked.
Held Open - When a door is not secured within the allowed time set in the reader
configuration.
High Temperature - The temperature in the room has risen above the set threshold.
Low Battery - The DC Battery in the field controller has dropped below the required
voltage.
Motion Detector - Alarm motion detector has been activated while not masked.
Request to Exit - A request to exit has been received from the reader door.
Smoke Detector - Auxiliary output from fire panel for a smoke detector has been
activated.
Standard Alarm - Other types of alarm points not covered by any other default alarm
category
System Input - Low Battery or AC Power Failure.
System Tamper - Field controller panel door has been opened.
Default Alarm Icons (user assignable/configurable)