Interlogix Topaz User Manual - Manual (Page 301)

Chapter 10
Badge Design
283
Editing Facilities
Any Picked object can be edited using the Edit commands. To select the edit menu, move the mouse
pointer to Edit on the menu bar at the top of the screen and click the left mouse pointer. A menu
appears with the following items:
Figure 191.Edit menu
Cut, Copy, Paste and Undo
The Cut, Copy, Paste, and Undo facilities follows the standard convention for these functions as in
most word processing or drawing software packages.
If you are not familiar with these conventions, the Cut facility, if selected, removes any Picked object
from the badge design. The Cut object is temporarily stored in memory. If the Paste command is
selected next, the Cut object appears in the last selected position on the badge.
The Copy command operates in the same way as the Cut command, but instead of removing the
Picked object a copy is stored in memory and the object remains on the badge. If you then move the
mouse pointer to a new position on the badge and click the left mouse button, selecting the Paste
command from the Edit menu places a copy of the Picked object at the selected position. Each
subsequent use of the Paste command places a copy of the picked object on the badge until either
the Cut or Copy command is used for a different Picked object.
Deleting Items From Template
To delete an unwanted field/item from the template, select the item by clicking on it to cause the
handles to appear. Click the Edit menu and select the Cut option from the menu.
Note: The Cut option is the only way to delete an item from the template.
• Cut
• Copy
• Paste
• Move Forward
• Move Backward
• Move to Front
• Move to Back
• Center L to R
• Center T to B
• Attributes
• Undo