Interlogix Topaz User Manual - Manual (Page 254)

Topaz
User Manual
236
Security Areas Select a Security Area from the list by scrolling through the list and clicking on the name of
the area so it is highlighted. Only elevator security areas appear in this list.
Note: Click the link arrow to set up an additional Security Area. When setup has been
completed, close the window by clicking Save/Add.
Time Schedule Select from the drop-down list the Time Schedule for this elevator public access area. The
Default is “Always”.
Note: Click the link arrow to set up additional Time Schedules. When setup has been
completed, close the window by clicking Save/Add.
SA Elevator Start Action There are two actions that are available for Elevator Stop Function. Select the action that
occur when the Time Schedule ends from the drop-down list. Options include:
• Public Access Enable
• Public Access Disable (default)
SA Elevator Stop Function There are two actions that are available for Elevator Stop Function. Select the action that
occur when the Time Schedule ends from the drop-down list. Options include:
• Public Access Enable
• Public Access Disable (default)
Save Once all the information has been added, click Save/Add.
One of the following messages should appear:
• If “Operation Complete” is displayed, no further changes are needed.
• If “Duplicate Record” is displayed, then the Public Access Name has been repeated.
Use a new name and try saving again.
• If “Operation Failed” is displayed, then a required field was not entered. Enter the field
and try saving again.
Clear At any point if you wish to clear out all entered information, click Clear.
CAUTION: Clicking Clear before clicking Save deletes newly entered data.
Delete Click to delete the selected public access area from the database.