Interlogix Topaz User Manual - Manual (Page 346)

Topaz
User Manual
328
Figure 224.Security Area Configuration
Click OK to exit the Security Area Configuration window.
Save your configuration changes by clicking Save Configuration in the center of the toolbar at
the top of your screen.
Note: If you do not save your changes, when you exit the program all changes are lost.
Outline Security Area
The security area on the map can be outlined with the same color as the icon’s outline. When the
area is masked the outline of the area is filled in with an overlay of mesh the same color as set for the
security area, as shown below.
Figure 225.Outline Security Areas
Note: The security area does not require an outline. If you do not want the mesh to appear when the area is masked,
then you should not outline it.
To outline the security area you must be in the configuration mode. After placing the security area on
the map, double-click the security area icon to outline. The Security Area configuration window
displays.
If the security area color has not been selected click Color and the color window displays.
Select the color from the Basic or Custom colors for area by clicking on the color block.
Note: Only one color can be selected for both the security area and the icon outlines.