Interlogix Topaz User Manual User Manual
Page 262
Topaz
User Manual
244
Begin/End Actions
The actions available for Begin Actions and End Actions are as follows:
• Access, No Keypad - Only a valid card for access is required.
• Access, Keypad - Only a keypad is required for access.
• Access, Company Mode - Access is granted if the Company Code on the card is correct.
• Access, Facility Code - Access is granted if the Facility Code on the card is correct.
• Lock Door - Door locks and no access is granted for any cardholder.
• Unlock Door- Door unlocks.
• Conditional Unlock - This options keeps the door locked until a cardholder with
Authorized for Conditional Unlock presents their card.
• Turn On Keypad Enter - Only a valid PIN is required for access.
• Turn Off Keypad Entry - A valid PIN is not required for access.
Duress Events Video
Switcher
Video Switch Alarm Number Enter the alarm number of the video switcher that should be activated when the reader's
duress alarm is generated. This field requires a video switcher alarm input.
For more information on duress, see
Video Switch Preset
To activate a preset on the video switcher when the duress alarm is activated, enter the
preset number of the video switcher that is to be activated.
Reader Alarm Video
Recorder
Topaz allows cameras on digital video recorders to be linked to readers so that alarms
generated at a reader can be recorded for investigation. See
information on configuring a Digital Video Recorder.
Note: Only alarms are recorded for investigation, so only those reader events that display
in the alarm window are tagged for recording.
DVMR Camera
This is the DVMR camera that is associated with an alarm event generated by this reader.
Select the camera from the drop-down list of available cameras. See
on page 262 for information on configuring a camera.
Save
After all changes have been made to the Reader Options page, click Save.
One of the following messages displays.
• If “Operation Complete” is displayed, then no further changes are needed.
• If “Duplicate Record” is displayed, then the Reader Name has been repeated. Enter a
new name and try again.
• If “Operation Failed” is displayed, then a required field was not entered. Enter the field
and try again.
Clear
At any point if you wish to clear out all entered information, click Clear.
CAUTION: Clicking Clear before clicking Save deletes newly entered data.