Interlogix Topaz User Manual - Manual (Page 379)

361
ACCESS AUTHORIZED - DELAYED ALARM UNMASKING STARTED
The cardholder has presented a valid card and PIN to Unmask the area and request was
authorized and the alarm delay timer was started allowing the cardholder time to exit the
area without set off the alarm.
ACCESS AUTHORIZED - ENTRY GRANTED TO MASK ALARMS
The cardholder has presented a valid card and PIN to Mask and enter the area. The
request was authorized and the alarms were Mask.
ACCESS AUTHORIZED - EXIT PUSH BUTTON
This is to notify you that someone has exited the area using the Exit Push Button.
Because it was the Push Button, the system cannot give a Cardholder Name. This event is
only available on the ACU-2 Card Reader.
ACCESS AUTHORIZED - FACILITY CODE
Access was granted based only on the Correct Company code and Facility code on the
card. Access on Facility code is set up in Reader Configuration.
ACCESS AUTHORIZED - FLOOR OK
Access was granted through a Card Reader set up for Elevator Control. This access event
code is only used by Local Elevator Control in the ACU-2 or dpC.
ACCESS AUTHORIZED - DURESS
Access was granted because this cardholder is under Duress. Access on Duress is user
configurable under the Site Configuration Menu.
ACCESS DENIED - ACCESS POINT NOT DEFINED
Access was denied because the reader is not defined.
ACCESS DENIED - ACTIVE ALARMS
A cardholder has presented a valid card and PIN to enter the area, but entry was denied
because the area alarms have not been Mask.
ACCESS DENIED - ANTI-PASSBACK VIOLATION
Access was denied because the cardholder has already used his/her card to enter the
security area without an intervening exit from the security area.