Interlogix Topaz User Manual - Manual (Page 331)

Chapter 11
Color Graphics Maps
313
Configuring Color Graphics
Adding Maps
To add a map to the Map Tree you must place the Topaz Color Graphics system into the
configuration mode. Do this by clicking the Go to Configuration Mode icon in the right end of the
toolbar. The icon changes to the Go to Online Mode icon showing you are in the configuration
mode.
When you have finished with the configuration, click Save Configuration and the following
message displays.
Click Yes to save the changes and then click Go to Online Mode to return to the Online Mode.
Click No to return to the configuration mode without saving any changes.
When you click Go to Online Mode to return to the online mode, if you have made changes,
and have not clicked Save Configuration the following message displays.
Clicking Yes disregards your changes and returns to the online mode.
CAUTION: While in the configuration, alarms linked to icons on the maps are updated until the color graphics
system is placed back online.