Artesyn ARTM-831X Installation and Use (June 2014) - Manual (Page 107)

FRU Information and SDR Summary
ARTM-831X Installation and Use (6806800M76E) 107
Depending on the RTM type, either one or 9 SFP TXFAULT sensors are visible. (SFP #2-9 on
DS3/OC3 only).
6.3.3 P(1-3) HA Status and P(1-3) Healthy Sensors
The P(1-3) HA Status sensors indicate its P(1-3) HA role master/slave (signal asserted/signal
deasserted). The P(1-3) Healthy sensors indicate healthy/not healthy (signal asserted/signal
deasserted).
6.3.4 Voltage and Temperature Sensors
The MMC provides the following voltage and temperature sensors:
Deassertion Event Mask (Byte 18) 0x00 -
Threshold/Reading Mask (Byte 19) 0x03 -
Threshold/Reading Mask (Byte 20) 0x00 -
Sensor Name SFP #<ID> TXFault -
Rearm Mode 1 Auto
Hysteresis Support 0x00 No Hysteresis
Threshold Access Support 0x00 No Thresholds
Event Message Control 0x00 Per Threshold /Discrete State
Reading Definition - -
Table 6-6 SFP TXFAULT Sensor (continued)
Feature Raw Value Description
Table 6-7 Voltage and Temperature Sensor Devices
I2C address Purpose Device
0x90 INLET temp RTM LM75
0x92 OUTLET temp RTM LM75
0x94 Mezz temp RTM
+12V RTM ADC