Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 100)

Maintenance and diagnostics
4-4 MicroEDGE Pro Instruction Manual 807290
Diagnostic tests
Note: Test kits are required to perform the following diagnostic tests.
Machine interface tests
If you are using a MicroEDGE Pro CNC, you can perform diagnostic tests with the following connectors and Phoenix
software to test the interface ports on the CNC (228831):
• Serial interface RS-232 on the motherboard
• Serial interface RS-422 on the serial isolation board
• Ethernet and Hypernet
• USB
Note: This is the only kit needed for SERCOS II and SERCOS III systems and it is included in the HyPath and
Picopath kits.
The HyPath version of the MicroEDGE Pro CNC offers the following, additional testers (228832):
• I/O (2)
• Axes
• THC
• Joystick and speedpot
The Picopath version of the MicroEDGE Pro CNC offers the following, additional testers (228833):
• I/O (2)
• Axes
• THC
• Joystick and speedpot
Machine interface test screen