Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 64)

InstallatIon
2-16 MicroEDGE Pro Instruction Manual 807290
The following illustration shows an encoder circuit in which the jumper setting puts voltage on Ve which supplies voltage
to the pull-up resistor on the encoder channels. The Ve voltage should equal the voltage on the encoder channel.
Refer to the instruction manual for your encoder to verify the encoder channel voltage or contact your table supplier.
Encoder circuit with jumper settings for voltage on encoder channels
Encoder Channel /A
Encoder Channel B
Encoder Channel A
Encoder Channel //B
From drive/encoder connectors
Encoder channel A
Encoder channel /A
Encoder channel B
Encoder channel /B
Ve
Ve
Ve
Ve
+5Vf
+5Vf
1 2
1 2
1 2
1 2
1
2 7
8
3 6
4 5
1
3
4
6
13
11
10
8
+
-
+
-