Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 87)

InstallatIon
MicroEDGE Pro Instruction Manual 807290 2-39
Adding a folder in Phoenix
Note: The Add Folders feature must be enabled in the Special Setups screen before you can perform these steps.
1. Restart the Phoenix software.
2. From the Main Screen, choose the Files soft key.
3. Double-click the blue message to add a folder.
4. In the dialog, choose Mapped Drive.
5. Enter a Drive Name. This is the name that appears in the Load Files list.
6. Enter the actual path to the drive, not a drive letter. The drive path is formatted \\servername\foldername.
7. Choose OK.