Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 108)

Maintenance and diagnostics
4-12 MicroEDGE Pro Instruction Manual 807290
LAN and Hypernet tests
The LAN and Hypernet tests both use the same tester.
Conduct this test if:
• The CNC is not communicating to the ArcGlide or plasma system.
• The CNC is not communicating to the local area network.
to test a LAN port:
1. On the Machine Interface screen, choose the LAN or Hypernet port.
2. Follow the instructions on the screen to plug in the tester.
3. On the Machine Interface screen, choose Test. A message informs you if the test is successful.
If either test fails, contact your OEM or system integrator to replace the motherboard.