Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 40)

SpecificationS
1-6 MicroEDGE Pro Instruction Manual 807290
Drive/encoder ports
Rear panel
The rear panel of the CNC has cable connectors for power, motion control feedback, I/O, and communication ports.
These connectors are clearly labeled with their function. There are four configurations available: HyPath, Picopath,
SERCOS II, and SERCOS III.
For more information about the electrical installation of the MicroEDGE Pro CNC, see Section 3, Installation.
Note: The rear panel shown below is for reference only. The rear panel on individual CNC units depends on which
configuration is ordered.
Rear panel of the Picopath MicroEDgE Pro CNC
Serial
ports on the
mother board
(RS-232)
USB
ports
Hypernet
port
AC
power
input
Optional
Sensor THC
ports (2)
I/O port
LAN
port
VGA
port
Optional joystick and
speedpot port
Serial
ports on the
serial isolation
board
(RS-422 or
RS-232)
Remote On/Off
Antenna ports
for optional
wireless I/O