Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 47)

SpecificationS
MicroEDGE Pro Instruction Manual 807290 1-13
Secondary enclosure requirements
If the MicroEDGE Pro CNC is installed in a secondary enclosure, the secondary enclosure must maintain the
environmental specifications for operation that are listed in System specifications in this section. In particular, the
temperature within the primary MicroEDGE Pro enclosure must not exceed 60° C (140° F).
The addition of auxiliary cooling may be required to insure that the internal temperature of the MicroEDGE Pro enclosure
remains within the system specification.
Interior temperature
During operation, the temperature of the utility PCB (141194, 141222, 141256, 141307) within the enclosure must
remain below 60° C (140° F).
The temperature of the utility PCB is reported on the Control Information screen in Phoenix software. The utility PCB
temperature can also be displayed in the Watch Window. To add this temperature monitor to the Watch Window:
1. From the Main screen, choose Setups > Watch.
2. Select Temperature from the Lower Location dropdown list.
3. Choose ok.
Air circulation
A space of 5 cm (2 in) must be maintained on the top and on all sides between the primary and secondary enclosures to
allow air to circulate adequately around the MicroEDGE Pro chassis.
AC input
The range for AC power entering the enclosure must be maintained within 50/60 Hz, 100 – 240 VAC.