Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 83)

InstallatIon
MicroEDGE Pro Instruction Manual 807290 2-35
Remote on/off cable
Hypertherm does not supply a cable that connects to the remote on/off connector on the following boards:
• 141222 for 4-axis HyPath and Picopath
• 141256 for 2-axis Picopath
• 141194/141307 for SERCOS II and SERCOS III
However, Hypertherm provides the cable connector which shipped with the system in the remote on/off port, as shown
in the following illustrations. You can use this connector to terminate a custom-built cable of the appropriate length.
Location of the remote on/off connector on the MicroEDgE Pro
Picopath and HyPath SERCOS II and SERCOS III
To build the remote on/off cable, remove the connector from the port and attach purchased wires, a switch, and an LED.
Use the circuit diagram below for details.
Circuit diagram for the remote on/off cable
Remote on/off +
Remote on/off -
Common
+12 V
Shield
On/Off
LED
Customer supplied wiring, switch
and LED
1
2
3
4
5