Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 109)

Maintenance and diagnostics
MicroEDGE Pro Instruction Manual 807290 4-13
joystick and speedpot test
Warning! to prevent motion on the table, disconnect all axis cables from the CNC before conducting this
test.
to test the joystick and speedpot port:
1. On the Machine Interface screen, choose the joystick/speedpot port.
2. Follow the instructions on the screen to connect the HyPath (purple) tester to the Joystick/Speedpot port, Axis 1-2
port and the I/O 1-6 port.
For a Picopath system, connect the or brown tester to the Joystick/Speedpot port, the X/Y port and the I/O port.
3. On the Machine Interface screen, choose Test. A message informs you if the test is successful.
If the test fails, contact your OEM or system integrator to check or replace these parts in the following order:
1. Analog field interface card
2. Ribbon cable
3. Analog interface card