Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 54)

InstallatIon
2-6 MicroEDGE Pro Instruction Manual 807290
Ground nut and lock
washer
#10-32
AC Power
connector
AC power
Fuse size – 2 Amp, 250 V slow-blow
Power cable
An AC power cable is standard equipment for North America, and is shipped with the MicroEDGE Pro CNC. For other
regions, the CNC is shipped with a power connector only to allow you to create a connector and cable combination that
meet the requirements of local code and power connections.
To create a power cable, use the plug (108842) that ships with the MicroEDGE Pro CNC and connect a 3-wire cable
for line, neutral, and ground signals according to local electrical codes. For more electrical specifications, see the Power
section of the System Specifications table in the Specifications section. Also see the drawings below for examples.
Note: The fuse block is universal and holds 1 fuse to comply with local electrical codes
VAC input wiring examples
L1 – line
L2 – line
PE ground
Power entry
module
L1 – line
Neutral
PE ground
Power entry
module
Customer-supplied power
(with neutral)
Customer-supplied power
(without neutral)
MicroEDgE Pro CNC
(as shipped)
1 fuse: 2 amp,
5 x 20 mm or
0.25" x 1.25"
1 fuse: 2 amp,
5 x 20 mm or
0.25" x 1.25"
MicroEDgE Pro CNC
(as shipped)