Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 106)

Maintenance and diagnostics
4-10 MicroEDGE Pro Instruction Manual 807290
Axis test
WARNINg!
Warning! to prevent motion on the table, disconnect all axis cables from the CNC before
conducting this test.
This test verifies axis operation. Conduct this test if there is:
• A runaway axis
• No motion
• Erratic motion
• A high number of position errors
• Multiple parts are not cut the correct size
to test an axis:
1. On the Machine Interface screen, choose the axis port you want to test.
2. Follow the instructions on the screen to connect the HyPath (green) or Picopath (blue) axis simulator board to the
CNC axis port you selected.
3. On the Machine Interface screen, choose Test. A message informs you if the test is successful.
If the test fails, contact your OEM or system integrator to check or replace these parts in the following order:
1. 4-axis servo field interface
2. Ribbon cable
3. MCC card