Chassis grounding, Chassis grounding -7 – Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 User Manual
Page 55
Advertising
InstallatIon
MicroEDGE Pro
Instruction Manual 807290
2-7
To the star ground on the cutting table
ground cable on the CNC
WARNINg
E
LECtRICAL SHoCk CAN kILL
this ground connection must be wired to insure safe and reliable operation.
Chassis grounding
The CNC must be properly grounded according to national and local electrical codes for safe operation. Use a
number 6 AWG (16 mm
2
) wire between the ground stud on the rear of the CNC to the cutting table as shown below.
Advertising