Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 78)

InstallatIon
2-30 MicroEDGE Pro Instruction Manual 807290
Side A Pin no. Wire color Signal Side B Pin no.*
1 Black Joystick up 1
2 White Joystick down 2
3 Red Joystick left 3
4 Green Joystick right 4
5 Brown Common 5
6 Blue Speed pot 1+ 7
7 Orange Speed pot 1- 8
8 Yellow Speed pot 2+ 11
9 Purple Speed pot 2- 12
*On Side B, there are no connections on pins 6,10 and 13 to 16.
joystick and speedpot cable adapter for MicroEDgE CNC (223252)
If the MicroEDGE Pro CNC is replacing a Hypertherm MicroEDGE CNC, an adapter cable is required to allow the cable
for the MicroEDGE joystick and speedpot to connect to the MicroEDGE Pro.
Side A
Connect to the MicroEDGE joystick and
speedpot cable
Side B
Connect to the MicroEDGE Pro joystick and
speedpot connector
1 3
4
6 4
7 9
2 1
3
7
11
8
12
5
2
5
8