Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 56)

InstallatIon
2-8 MicroEDGE Pro Instruction Manual 807290
Interface ports
Hypernet interface
The Hypernet interface allows a Hypernet connection to a Hypernet-enabled system, such as the ArcGlide THC.
LAN interface
The RJ-45 Ethernet interface allows the MicroEDGE Pro to connect to a local area network (LAN) for downloading
parts and using Remote Help.
For more information on LAN setup, see the Phoenix Software Installation and Setup Manual.
USB interface (5)
The USB 2.0 ports can be used to load programs or connect a USB keyboard, mouse, or touchscreen.
Serial ports (4)
The MicroEDGE Pro has 4 serial ports that use D-sub 9-pin connectors.
Two RS-232 serial ports (COM 1 and COM 2) are located on the motherboard.
Two more serial ports (COM 3 and COM 4) are located on all versions of the serial isolation board:
• 141222 for 4-axis HyPath and Picopath
• 141256 for 2-axis Picopath
• 141194/141307 for SERCOS II and SERCOS III
Transmission rate is up to 115K Baud. Both ports are preset with RS-422 as the default but both can be configured
for RS-232. For more information, see Serial port configuration in this section and in the Maintenance and Diagnostics
section.
VgA Port 1
The VGA port allows connection of an video monitor (touchscreen, LCD, or CRT).