Mounting the cnc, Mounting hole patterns on the bottom of the cnc, Mounting the cnc -4 – Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 User Manual
Page 52: Mounting hole patterns on the bottom of the cnc -4
Advertising
InstallatIon
2-4
MicroEDGE Pro
Instruction Manual 807290
Mounting the CNC
Before you configure the MicroEDGE Pro CNC, mount all system components using the appropriate instructions.
Do not allow the system components to lie unsecured on top of cabinets or on the floor.
front and Side Views of the MicroEDgE Pro CNC
MicroEDgE Pro mounting pattern
Mounting hole patterns on the bottom of the CNC
If you are upgrading from a MicroEDGE CNC to a MicroEDGE Pro, the mounting bolt patterns are the same on both
systems.
463 mm
(18.22 in)
238 mm
9.38 in
332 mm
(13.08 in)
483 mm
(19 in)
279 mm
(11 in)
.281 in. diameter for
1/4 in. or
6 mm bolts
Advertising