Hypertherm MicroEDGE Pro Shape Cutting Control Rev.2 - Manual (Page 85)

InstallatIon
MicroEDGE Pro Instruction Manual 807290 2-37
1. After selecting a suitable antenna mounting location, drill two 6.35 mm (.25 in) holes into the secondary CNC
enclosure as shown below (drawing not to scale). Remove any burrs inside and outside.
2. Thread each bulkhead-mount antenna base through a hole and secure with a lock washer and nut. Be sure the
antenna base makes contact with unpainted metal on the enclosure to ensure proper grounding.
3. Connect the antennas to the bases and point them skyward.
4. Connect the cables to the coaxial connectors on the wireless network card. Be sure to avoid twisting or kinking
the cables. The entire extension cable should be within the CNC enclosure. Only the antennas are mounted on the
outside of the enclosure.
5. Restore AC power to the CNC.
Checking the wireless network in Windows
The MicroEDGE Pro comes from the factory with the wireless network card drivers installed. To check the wireless
network in Windows:
1. Turn on the MicroEDGE Pro.
2. Choose Setups>Password and enter the Special Setups password.
3. Choose System>Network Tools. The Network Connections dialog opens showing all network connections.
36 mm (1.4 in)
6.35 mm (.25 in)
diameter