Grass Valley Kaleido-X v.7.80 - Manual (Page 226)

218
Setting Up Rooms
Configuring Displays
Example: Suppose you want to configure the display that is connected to head 1 of a
Kaleido-X (7RU) multiviewer’s OUTPUT D card. The image below shows the relevant data
you need to copy to the Modeline section of the Edit Resolution Settings window.
Note: In XAdmin’s Status and Options page, these parameters are listed
under the corresponding output card information, according to the
blank/sync start/end modeline system, and with the sync polarity expressed
as a number between 0 and 3. Refer to
Viewing a Multiviewer’s Status
Information , on page 534 for details.