HEIDENHAIN MSE 1000 - Manual (Page 28)

Installation
Data interface connections
28 Operating Instructions
5.2.2 Connecting a network cable
15
RJ-45 connector
MSE modules communicate with a PC workstation through an RJ-45 connection 15
located on the base module. Use a straight-through cable when connecting to a DHCP
router. A crossover cable may be required when connecting the workstation directly
to the base module. Refer to the documentation provided with the NIC for additional
information.
To connect a network cable:
Verify power is removed from all power supply modules in the module chain.
With the cable connector locking tab facing up, insert the cable connector into the
RJ-45 connection
15 on the module until the tab locks into place.
5.2.3 Connecting an EnDat encoder
16
EnDat encoder
connector
This product can be used with HEIDENHAIN length gauges, linear encoders and rotary
encoders that provide EnDat signals. The connecting cable must not exceed 100
meters in length.
To connect an EnDat encoder:
Verify power is removed from all power supply modules in the module chain.
Align the encoder cable connector notch with the module encoder connection
notch.
Insert the cable connector into the encoder connection 16 and tighten the cable
connector by turning clockwise until it is snug.