HEIDENHAIN MSE 1000 - Manual (Page 29)

Installation
Data interface connections
Operating Instructions 29
5.2.4 Connecting a TTL encoder
17
TTL encoder
connector
This product can be used with HEIDENHAIN encoders that provide TTL signals. The
connecting cable must not exceed 30 meters in length.
To connect a TTL encoder:
Verify power is removed from all power supply modules in the module chain.
Connect the encoder cable connector to the encoder connection 17 on the module
and tighten the cable connector screws until they are snug
5.2.5 Connecting a 1 V
PP
encoder
18
1 V
PP
encoder
connector
This product can be used with HEIDENHAIN linear and rotary encoders that provide
1 V
PP
signals. The connecting cable must not exceed 30 meters in length.
To connect a 1 V
PP
encoder:
Verify power is removed from all power supply modules in the module chain.
Connect the encoder cable connector to the encoder connection 18 on the module
and tighten the cable connector screws until they are snug.
5.2.6 Connecting a 9-pin D-sub connector
19
9-pin D-sub connector
This product provides a 9-pin D-sub connector for input of analog signals. The
connecting cable must not exceed 30 meters in length.
To connect a 9-pin D-sub connector:
Verify power is removed from all power supply modules in the module chain.
Connect the cable connector to the 9-pin D-sub connection 19 on the module and
tighten the cable connector screws until they are snug
5.2.7 Connecting a transducer
20
Transducer connector
This product can be used with select Solartron, Tesa, Marposs and Mahr half-
bridge and LVDT transducers. Refer to the transducer documentation for maximum
connecting cable length.
To connect a transducer:
Verify power is removed from all power supply modules in the module chain.
Align the transducer cable connector notch with the module transducer connection
notch
Insert the cable connector into the transducer connection 20 and tighten the cable
connector by turning clockwise until it is snug