TA Triumph-Adler DC 2062 - Manual (Page 15)

Section 2 NAMES OF PARTS
2A080030A
KM-6230 (KME)
/ 131
(1) Main body
1 Front cover
2 Operation panel
3 Original size indicator lines
(When setting an original on the platen, align it with the appropriate
lines.)
4 Platen
5 Cover on the right side of the operation panel
(Open this cover when adding toner.)
6 Original tray
(Depending upon the country or region where you purchased your
copier, this part may not be included.)
7 Right upper cover
(Open this cover if paper misfeeds in the paper feed section.)
8 Right lower cover
(Open this cover if paper misfeeds in the paper feed section.)
9 Front Deck
(Holds up to 3,000 sheets of standard [75 g/m 2 or 80 g/m 2 ] paper.)
0 Drawer 1
(Holds up to 500 sheets of standard [75 g/m 2 or 80 g/m 2 ] paper.)
! Drawer 2
(Holds up to 500 sheets of standard [75 g/m 2 or 80 g/m 2 ] paper.)
@ Paper width guides
# Paper length guide
$ Stack bypass tray
(Load paper here when copying onto small-size or special paper.)
% Support extension
^ Insert guides
& Paper feed section knob
(Turn this knob to remove paper that has been misfed in the paper
conveyor section.)
* Paper conveyor section
( Paper conveyor section release lever
(Operate this lever if paper misfeeds in the paper conveyor section.)
) Fixing unit
⁄ Fixing unit knob
(Turn this knob to remove paper that has been misfed in the fixing
unit.)
¤ Total counters
(The number displayed on the upper line indicates the number of origi-
nals that have been scanned for copying. The bottom line indicates
the number of copies made.)
‹ Instruction handbook box
(Keep the instruction handbook here.)
› Transport handles
(Use these handles when moving this machine. There are a total of
four transport handles in all.)
fi Paper ejection cover
(Open this cover if paper misfeeds in the fixing unit or ejection sec-
tion.)
fl Main switch
(Turn this switch ON ( | ) before copying.)
‡ Waste toner tank cover
(Open this cover when replacing the waste toner tank.)
Waste toner tank
● DF (Document Feeder)
(Automatically feeds and scans each original, one by one, for copying.)
· Original table
(Set the originals that you want to copy on this table.)
‚ Original insert guides
(Adjust these guides to match the width of the originals set in the DF.)
ΠOriginal set indicator
(Indicates the status of the originals in the DF.)
Lights green: The originals are set properly. Press the Start key to start
copying.
Blinks green: The originals are not set properly. Reset the originals in
the DF.
Blinks red: An original has been misfed. See page 10-11 and remove
the misfed originals.)
„ DF open/close handle
(Hold this handle when opening and closing the DF.)
´ Original ejection table
(Copied originals are stored here.)
‰ Original reversing cover
(Open this cover if an original misfeeds in the DF.)
ˇ Original ejection guide
(Open this guide when copying from originals of 8-1/2" x 14" [A4] or
larger.)
● Duplex unit
(Paper is turned over in this unit when you make two-sided copies.)
Á Re-feeding section
¨ Duplex cover
(Open this cover if paper misfeeds in the duplex unit.)
2-2
E_Sec2_Name.PM6 10/13/00, 13:36 3