TA Triumph-Adler DC 2062 - Manual (Page 152)

Section 10 TROUBLESHOOTING
2A080030A
KM-6230 (KME)
/ 131
4. If the misfed paper is in the re-feeding section, remove it.
5. If it is not in the re-feeding section, lift up on the duplex cover.
6. If the misfed paper is under that cover, remove it.
Close the duplex cover and go to step 9.
* If the misfed paper is still not visible, it should be under the paper reversing cover. In
this case, go to the next step.
7. Unscrew the two reversing cover screws a located on the left side of the duplex unit.
The paper reversing cover b will open downwards.
8. Remove the misfed paper without tearing it. Close the paper reversing cover and
fasten it with the same 2 screws.
* If the paper does happen to tear, remove any loose scraps from inside the copier.
9. Push the duplex unit all the way back into its original position in the copier.
10. Close the front cover.
5 5 5 5 5 Misfeed in the DF
If “PAPER MISFEED.” and the misfeed location indicator shown in the illustration ap-
pear on the touch panel, an original has misfed in the DF.
10-11
a
b
;
;
;
;