Kyocera FAX System 12 - Manual (Page 190)

8-10
Fax Settings > Default fax settings
FAX Local FAX Number 1 Register the local FAX number printed in the transmit terminal identification
(TTI) area.
If you have already registered a number, the current registered number is
displayed.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-11)
Local FAX Number 2 *1
Dialing Mode (Port 1)
(Inch version only) Select the telephone line according to the type you are contracted with.
Please note that selecting a wrong telephone line will prevent you from
sending fax.
Value : Tone(DTMF), Pulse(10PPS)
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-11)
Dialing Mode (Port 2) *1
(Inch version only)
Local FAX ID Register the local FAX ID.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-11)
NOTE: The Local FAX ID is used for transmission limit purposes.
Transmission Restriction (page 8-15)
ECM TX (Port1) Set whether ECM TX is performed.
ECM is a communication mode specified by the ITU-T (International
Telecommunication Union) that retransmits data when an error occurs. Fax
machines that have ECM mode check for errors as they communicate,
preventing distortion of the image due to noise on the line and other
conditions.
Value : On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when [Off] is selected.
ECM TX (Port2) *1
TX Start Speed (Port1) Set the TX Start Speed.
When communication conditions are bad, the fax may not be transmitted
correctly. In that case, set a lower TX Start Speed.
Value : 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
TX Start Speed (Port2) *1
*1 This function is displayed when 2 optional FAX Kits (Dual FAX option) are installed.
Item Description