Kyocera FAX System 12 - Manual (Page 73)

3-28
Sending Faxes > File Name Entry
File Name Entry
Adds a file name.
Additional information such as job number and date and time can also be set. You can check a job history or job status
using the file name, date and time, or job number specified here.
Select [File Name], enter the file name (up to 32 characters), and select [OK].
To add date and time, select [Date and Time]. To add job number, select [Job No.]. The added information will be
displayed in "Additional Info".
FAX Direct Transmission
The destination is dialed and communication starts before the original is scanned, allowing you to verify that each page
of the fax has been properly sent.
Cancelling Direct Transmission
During direct transmission, to cancel communication during transmission, select the [Stop] key on the operation panel or
[Cancel] on the touch panel. The originals that have been scanned are ejected, and the screen returns to the send
default screen. When originals remain in the document processor, take them out.
Setting for Direct transmission Description
On Starts direct transmission.
Dials the receiving system, and after the communication has started, originals
are scanned.
Off Starts memory transmission.
After originals are scanned into memory, the communication starts.
NOTE
In direct transmission, you can designate only one destination for one transmission.
In the basic screen for sending, select [Direct]. This selects the direct transmission method and the keys on the touch
panel are highlighted.
NOTE
In some cases, transmission may take place even if the [Stop] key or [Cancel] is selected.