Kyocera FAX System 12 - Manual (Page 221)

10-11
Internet Faxing (i-FAX) > i-FAX transmission procedure
4
Configure the detailed settings.
1 "Mode" [ ] > [Simple] or [Full]
2 "Via Server" [ ] > [On] or [Off].
When this setting is set to [Off], transmission takes place by direct SMTP (not through an
e-mail server).
When this setting is set to [On], transmission takes place by the i-FAX method (through an
e-mail server).
5
Specifying the Destinations Conditions.
Select [Destination Condition].
The available settings are shown below.
6
Selecting the functions.
Grayed out items cannot be set.
7
Press the [Start] key.
When scanning finishes, transmission starts.
NOTE
The settings are automatically configured based on the i-FAX transmission type that is
set in Command Center RX. When the transmission type is set to [Specify for Each
Destination], these settings can be configured.
Item Description
Resolution Specify the resolutions that can be received by the destination fax
machine.
If you try to send an i-FAX using a prohibited resolution, it is
automatically changed to a permitted resolution and then sent.
• 200 × 100 dpi: Permitted (fixed)
• 200 × 200 dpi: Permitted (fixed)
• 200 × 400 dpi: Permitted or prohibited
• 400 × 400 dpi: Permitted or prohibited
• 600 × 600 dpi: Permitted or prohibited
To permit a resolution setting, press the key for that resolution so
that it is highlighted.
To prohibit a resolution, press the key again so that it is no longer
highlighted.
Compressio
n Select a suitable file format for the destination fax machine.
MH, MR, MMR or JBIG
Paper Size Display the sending paper size for the destination fax machine. If
you try to send an i-FAX using a prohibited paper size, it is
automatically changed to a permitted paper size and then sent.
• A4/Letter: Permitted (fixed)
• B4: Permitted or prohibited
• A3/Ledger: Permitted or prohibited
Fax transmission functions (page 3-18)